Jayhawk
Mini Jig with Drill Press
Order
#15-1180: 1/2” Straight Shank Jet Drill Press, 110 volt/60 cycle
Order #15-1180-1: 1/2” Straight Shank Jet Drill Press, 220 volt,
60 cycle
Order #15-1180-2: 1/2” Straight Shank Drill Press, 220 volt, 50
cycle
#2 Taper Model may be special ordered upon request
Order #15-1175: Jig Only
The Mini
Mill is a very economical choice for getting started. While very simple
to operate, the Jayhawk quality is still there. This unit is built to
provide many years of trouble-free operation.It uses a small milling type
table giving the operator manhy of the conveniences of the larger milling
machines. The machine is fully assembled in our factory saving you time
during the setup process. At Jayhawk, we have proven that this is the
only way to insure that your new machine is assembled and calibrated properly.
Features:
X &
Y table movements allow operator to provide accurate service to their
customers.
Operator
has complete control of all pitches with easy to read scales.
Adjustabel
rubber tipped clamps assure positive clamping during the drilling process.
All parts
are anodized and powder painted to provde years of trouble-free operation.
Minimal
set up required. Machine is fully assembled and calibrated in our factory
allowing you to spend more time with your customers.
Bench model
allows for use of minimal bench space.
Complete
instruction manual and a Jayhawk span rule will be included with every
machine.
Complete
one year warranty.
Common
Questions about the Mini Jig:
I already
have a drill press, can I purchase the jig only??
Yes. The jig
is easily mounted to the drill press table by 2 bolts nthat are provided
with the jig. If using your own drill press, the spindle must have
at least 5” of travel (15-1175 jig only)
How much
bench space does the Mini Jig need??
The base plate
on this machine is only 16” wide. For operation you should allow 24”
in width and your bench should be at least 24” deep.
Does the
Mini Jig require much maintenance??
The only maintenance
needed is occasional lubrication to the table travel rods. This is
the same that you would do with any machine with moving parts.
Can I drill
into an existing hole??
Yes. You can
drill into existing holes, put in slugs or grips just like the big
machines, One quick note. A drill press was never designed to drill
anything but staright holes. Because of this, extreme care should
be used when drilling large holes. Also remember that the higher the
speed you drill, the more chance for vibration. Approximately 450
RPM.
On many
other jigs like the Mini Jig, the tables become very sloppy. In time,
will that happen to the Mini Jig, too??
Anytime you
have metal parts they will show wear in time. However, the Mini Jig
has ajustable table slides for each table allowing the operator to
tighten the slides in a matter of minutes. This will allow you to
maintain the high level of accuracy that you have come to depend on
from your Jayhawk Mini Jig.
What if
I need service for my pro shop equipment??
Jayhawk Bowling
Supply has been in the pro shop business for more than 35 years. Our
company has been building many of its own products during this time.
We are very proud that we have qualified staff at our toll-free number
during regular business hours. We are comjmitted to providing the
best products combined with the best customer service in the industry
75.JPG)
type
table giving the operator manhy of the conveniences of the larger milling
machines. The machine is fully assembled in our factory saving you time
during the setup process. At Jayhawk, we have proven that this is the
only way to insure that your new machine is assembled and calibrated properly.